Skip Function; Designating A Skip-Frequency - Sony ICF-SC1 Operating Instructions (primary manual) Operating Instructions Manual

SKIP function

You can designate any frequency as a SKIP-frequency (up
to 100). The receiver will skip this frequency during
scanning. Designate any unwanted frequency
(interference signals, etc.) as a SKIP-frequency.

Designating a SKIP-frequency

1
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
Tune in, by any way, to a frequency you wish to
2
specify as a SKIP-frequency.
Press SKIP.
3
The frequency is designated as a SKIP-frequency.
To cancel SKIP designation
Press SKIP again.
SKIP-frequency designation is effective for any of the Scanning
Modes.
To display the SKIP-frequencies
Press +/- while holding down SKIP.
The SKIP-frequencies will be displayed one by one in
ascending/descending order.
When there is no SKIP-frequency, the following display will
appear momentarily, and then the receiver will return to the
previous status.
Note
You can designate up to 100 SKIP frequencies. If you try to
designate a SKIP-frequency when there is already 100, the
following display will appear momentarily, and then the receiver
will return to the previous status.
In this case, cancel a previously designated SKIP-frequency first.
2 8
SKIP