Change Receiver ID
Set output channel
Input key enable/disable
Lock a channel
Use the
PREFERENCES
appearance of the on-screen menus and select how your DIRECTV Receiver
operates with other devices. The
• Change the receiver ID
• Set the receiver output channel to channel 3 or 4
• Enable or disable the
• Lock the system on a particular channel.
• Select English or Spanish language menus.
• Enable or disable Caller ID on and off.
If you are using a second satellite receiver in the same room, or you are using
the RF remote control, you may want to change the receiver ID to avoid
interference or "cross talk." The remote control receiver ID can be either "50"
or "51." When using the RF antenna with the SAT-A65 receiver, the ID can be a
number from "00" to "15."
If you change the receiver ID, set your remote control to the desired ID number
first. Use this procedure to set the remote control to use a different receiver ID:
1. Press the
CODE SET
2. Enter the desired receiver ID number, either "50" or "51" or a number from
"00" to "15" when using the the RF antenna with the SAT-A65 receiver and
the RM-Y807 remote control.
3. Test the remote control to ensure that it will control the DIRECTV receiver.
Use the Output Channel menu button to toggle between channels 3 and 4,
whichever is unused in your area.
The Input Key menu button allows you to turn the remote control
button on and off.
Use the Channel Set menu button to set the DIRECTV Receiver to permanently
stay on a specific channel. When you enter a channel number (5-0-0, for
example) then select OK, the receiver will always power up on that channel
(channel 500 in this example). The receiver will ignore any attempts to change
the channel. Set this option to "Off" to permit normal channel selection.
menu pane (shown in the figure below) to change the
PREFERENCES
button on your remote control.
INPUT
System Preferences menu pane
button on the remote control.
pane also allows you to:
TV/SAT
25
Using the menus