Sony VPL-AW10 Operating Instructions (VPLAW10 and VPLAW15) Operating Instructions Manual page 56

4
Loosen the three screws on the
lamp with the Phillips
screwdriver. Hold up the handle,
then pull the lamp straight out.
5
Hold the handle of the new lamp
and push it in securely until it
reaches the end, and then
tighten the 3 screws.
Notes
• Be careful not to touch the optical block
inside the unit.
• If the 3 screws are not tightened
securely, the lamp cover will not close.
56
6
Close the lamp cover, then
tighten the screws.
Note
If the lamp cover is not set securely, the power
will not turn on.
7
Remove the air filter cover.
8
Remove the air filter.