Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for HIKVISION DarkfighterX
- Page 1 DarkfighterX Outdoor Smart Camera Quick Start Guide...
- Page 2 Any and all information, including, among others, wordings, pictures, graphs are the properties of Hangzhou Hikvision Digital Technology Co., Ltd. or its subsidiaries (hereinafter referred to be “Hikvision”). This user manual (hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision.
- Page 3 LOSS OF BUSINESS PROFITS, BUSINESS INTERRUPTION, OR LOSS OF DATA OR DOCUMENTATION, IN CONNECTION WITH THE USE OF THIS PRODUCT, EVEN IF HIKVISION HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. REGARDING TO THE PRODUCT WITH INTERNET ACCESS, THE USE OF PRODUCT SHALL BE WHOLLY AT YOUR OWN RISKS.
- Page 4 DarkfighterX Outdoor Smart Camera·Quick Start Guide IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE APPLICABLE LAW, THE LATER PREVAILS. Regulatory Information FCC Information Please take attention that changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- Page 5 DarkfighterX Outdoor Smart Camera·Quick Start Guide EU Conformity Statement This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable harmonized European standards listed under the EMC Directive 2014/30/EU, the RoHS Directive 2011/65/EU.
- Page 6 DarkfighterX Outdoor Smart Camera·Quick Start Guide Warning: This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss.
- Page 7 DarkfighterX Outdoor Smart Camera·Quick Start Guide ● In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region. Please refer to technical specifications for detailed information. ● Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source with 24 VAC according to the IEC60950-1 standard.
- Page 8 DarkfighterX Outdoor Smart Camera·Quick Start Guide gently. If the camera will not be used for an extended period, please replace the lens cap to protect the sensor from dirt. ● Do not aim the camera at the sun or extra bright places.
- Page 9 DarkfighterX Outdoor Smart Camera·Quick Start Guide only. Dispose of used batteries according to the instructions provided by the battery manufacturer. ● If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself.
-
Page 10: Table Of Contents
DarkfighterX Outdoor Smart Camera·Quick Start Guide Table of Contents 1 Appearance Description ............... 10 2 Installation ..................12 2.1 Memory Card Installation ..........12 2.2 Camera Mounting ............13 2.3 Zoom and Focus Adjustment ......... 15 3 Setting the Network Camera over the LAN ........16 3.1 Wiring ................ -
Page 11: Appearance Description
DarkfighterX Outdoor Smart Camera·Quick Start Guide 1 Appearance Description The overview of the box camera is shown below: Top View Without Housing Rearview Without Housing Overview of the Camera... - Page 12 DarkfighterX Outdoor Smart Camera·Quick Start Guide Description Description Lens Buckle Cable Outlet Housing Memory Card Slot Reset RS485 Interface Alarm Input Interface Alarm Output Interface Network Interface Audio Output Interface Audio Input Interface Power Interface (24 VAC) Note: Use a toothpick or a thin stick to press the reset about 10s when the camera is powering on or rebooting to restore the default settings, including the username, password, IP address, port No., etc.
-
Page 13: Installation
DarkfighterX Outdoor Smart Camera·Quick Start Guide 2 Installation Before you start: ● Make sure the device in the package is in good condition and all the assembly parts are included. ● The standard power supply is 24 VAC, please make sure your power supply matches with your camera. -
Page 14: Camera Mounting
DarkfighterX Outdoor Smart Camera·Quick Start Guide (Optional) If you want to unmount the memory card, push to get it ejected. Memory Card Installation Camera Mounting Before you start: With brackets, the camera supports wall mounting, pole mounting, and pendant mounting. The brackets are not included in the package and should be purchased separately. - Page 15 DarkfighterX Outdoor Smart Camera·Quick Start Guide Wall Wall Mount Figure 2-2 Install the Bracket to Mounting Place Fix the camera onto the bracket with the supplied screws. Pole Mount Adjustment Screw Pole...
-
Page 16: Zoom And Focus Adjustment
DarkfighterX Outdoor Smart Camera·Quick Start Guide Figure 2-3 Fix the Camera to Brackets Loosen the adjusting screw to adjust the surveillance angle of the camera. Tighten the screw after adjustment. Unbuckle the housing to open the camera, connect the cables through the cable outlet. -
Page 17: Setting The Network Camera Over The Lan
DarkfighterX Outdoor Smart Camera·Quick Start Guide 3 Setting the Network Camera over the Note: You shall acknowledge that the use of the product with Internet access might be under network security risks. For avoidance of any network attacks and information leakage, please strengthen your own protection. -
Page 18: Activating The Camera
DarkfighterX Outdoor Smart Camera·Quick Start Guide Network Camera Computer Connecting via a Switch or a Router Figure 3-2 Activating the Camera You are required to activate the camera first by setting a strong password for it before you can use the camera. - Page 19 DarkfighterX Outdoor Smart Camera·Quick Start Guide Notes: The default IP address of the camera is 192.168.1.64. The computer and the camera should belong to the same subnet. For the camera enables the DHCP by default, you need to use ...
-
Page 20: Activation Via Sadp Software
DarkfighterX Outdoor Smart Camera·Quick Start Guide 3.2.2 Activation via SADP Software SADP software is used for detecting the online device, activating the camera, and resetting the password. Get the SADP software from the supplied disk or the official website, and install the SADP according to the prompts. -
Page 21: Modifying The Ip Address
DarkfighterX Outdoor Smart Camera·Quick Start Guide 3. Create a password and input the password in the password field, and confirm the password. STRONG PASSWORD RECOMMENDED– We highly recommend you create a strong password of your own choosing (using a minimum of 8 characters, including... - Page 22 DarkfighterX Outdoor Smart Camera·Quick Start Guide 1. Run the SADP software. 2. Select an active device. 3. Change the device IP address to the same subnet with your computer by either modifying the IP address manually or checking the checkbox of Enable DHCP.
- Page 23 DarkfighterX Outdoor Smart Camera·Quick Start Guide 4. Input the admin password and click Modify to activate your IP address modification. The batch IP address modification is supported by the SADP; please refer to the User Manual of SADP for details.
-
Page 24: Accessing Via Web Browser
DarkfighterX Outdoor Smart Camera·Quick Start Guide 4 Accessing via Web Browser System Requirement: Operating System: Microsoft Windows XP SP1 and above version CPU: 2.0 GHz or higher RAM: 1G or higher Display: 1024×768 resolution or higher ... - Page 25 DarkfighterX Outdoor Smart Camera·Quick Start Guide The device IP address gets locked if the admin user performs 7 failed password attempts (5 attempts for the user/operator). 4. Click Login. Login Interface Figure 4-1 5. Install the plug-in before viewing the live video and managing the camera.
- Page 26 DarkfighterX Outdoor Smart Camera·Quick Start Guide For detailed instructions of further configuration, please refer to the User Manual of Network Camera.
- Page 27 UD06491B...