Charging The Battery Pack - Sony DPP-FPHD1 Instruction Manual (Photo Printer) Operating Instructions Manual

Charging the battery pack

Turn off the camera and place the camera
with the battery pack inserted on the camera
adaptor. Charging starts automatically. The
CHARGE indicator of the camera adaptor
lights up.
When the camera is turned on, the camera
•
adaptor stops charging the battery pack.
When the charging reaches to Normal
•
charge*, the CHARGE indicator goes off.
* Recording and playback time with Normal
charge is approximately 90% of Full charge.
The time of the full-charge for a
•
completely discharged battery at the
temperature of 25 °C (77 °F) is
approximately 230 minutes.
It may take longer to charge, depending
on the charging condition and
environment.
If the motor in the printer is still running,
•
turn off the camera after the motor stops
running. You cannot charge the battery
while the motor is running.
If CHARGE indicator fails to light or
•
blinks for more than 10 seconds, refer to
"Troubleshooting".
After attaching the camera to the camera
•
adaptor, the CHARGE indicator may flash
for 3 to 10 seconds. This indicates
communication between the camera and
the camera adaptor, and it is not a
malfunction.
Charging temperature
The temperature range for charging is 0 °C
to 40 °C (32 °F to 104 °F). However, to
provide maximum battery efficiency, the
recommended temperature range when
charging is 10 °C to 30 °C (50 °F to 86 °F).
20