Fading In And Fading Out - Sony MDS-JE780 Operating Instructions Manual

Finely controlling the pitch
(Fine Control Function)
You can fine control the playback speed in 0.1%
increments from the factory setting ("Off") to
–87.5%.
1
While the deck is stopped, playing, or
paused, press MENU/NO.
2
Turn AMS (or press ./>
repeatedly) until "Setup?" appears,
then press AMS or YES.
3
Turn AMS (or press ./>
repeatedly) until "Pfine" appears, then
press AMS or YES.
4
Turn AMS (or press ./>
repeatedly) to adjust the pitch, then
press AMS or YES.
5
Press MENU/NO.
To recall the factory setting
Press CLEAR while setting the value.
Notes
• When you change the fine control value, the
playback sound drops out momentarily.
• The playback sound may be interrupted when you
adjust the pitch from "Off" or return the pitch to
"Off."
• The fine control value turns to "Off" (factory
setting) when you turn off the deck or eject the MD.
• The step and fine control values are linked; changing
one value also changes the other.
40
GB

Fading in and fading out

You can use Fade-in Play to gradually increase
the signal level to the ANALOG OUT jacks and
the PHONES jack at the start of playing. Fade-
out Play gradually decreases the signal level at
the end of playing.
Fade-in Recording gradually increases the
signal level at the start of recording. Fade-out
Recording gradually decreases the signal level
at the end of recording.
Note
The level of the signal output from the DIGITAL OUT
connector does not change during Fade-in Play or
Fade-out Play.
Fade-in Play and Fade-in
Recording
During play pause (for Fade-in Play) or
recording pause (for Fade-in Recording),
press FADER on the remote.
b flashes in the display and the deck performs
Fade-in Play or Fade-in Recording for five
seconds (factory setting) until the counter
reaches "0.0s."
Fade-out Play and Fade-out
Recording
During play (for Fade-out Play) or
recording (for Fade-out Recording), press
FADER on the remote.
B flashes in the display and the deck performs
Fade-out Play or Fade-out Recording for five
seconds (factory setting) until the counter
reaches "0.0s," then pauses.