Changing The Recorded Level After; Undoing The Last Edit - Undo - Sony MDS-JE770 Operating Instructions Manual

Changing the recorded level after

recording (continued)
Fade-in and Fade-out
Recording
1
While the deck is stopped, playing, or
paused, press MENU/NO.
"Edit Menu" appears in the display.
2
Turn AMS (or press
repeatedly) until "S.F Edit?" appears,
then press AMS or YES.
3
Turn AMS (or press ./>
repeatedly) until "Fade In?" or "Fade
Out?" appears, then press AMS or YES.
4
Turn AMS (or press ./>
repeatedly) until the track number you
want to change the recording level
appears, then press AMS or YES.
"Time 5.0s" appears in the display.
5
While monitoring the sound, turn AMS
(or press ./> repeatedly) to
change the Fade-in or Fade-out
Recording time.
The deck plays the portion that will be
recorded over using Fade-in or Fade-out
Recording.
You can set the time at any value between
1 second and 15 seconds, in 0.1 second
increments. You cannot set the time longer
than the track.
6
Press AMS or YES.
"(S.F) Edit OK?" appears in the display.
7
Press AMS or YES again.
The deck starts recording over the existing
track. "S.F Edit(:) ** %" appears while the
track is being recorded. When the recording
finishes, "Complete!" appears.
To cancel the operation
Press MENU/NO or x in steps 1 to 6. If you
press AMS or YES in step 7 and recording
starts, you cannot interrupt the operation.
Notes
• Do not disconnect the AC power cord or move the
deck while recording is in progress. This may
damage the recording data preventing recording
from being performed properly.
• You cannot change the recorded level of a track
recorded in LP2 or LP4 Stereo mode.
34
./>
• Do not use an MD that is damaged or dirty. This
may prevent recording data from being recorded
properly.
• Repeatedly changing the recording level results in
poor sound quality.
• The recording level will not return to the exact
original level once the recording level has been
changed even if it returned to the original level.
• The recording level cannot be changed while the
timer is activated.
• You cannot undo any S.F edit operation with the
Undo Function.
Undoing the last edit
— UNDO
You can undo the last edit operation and restore
the contents of the MD to the condition that
existed before the operation. Note, however,
that you cannot undo an edit operation if you
perform any of the following operations after
the edit:
• Start recording.
• Press MUSIC SYNC on the remote.
• Change the recorded level after recording (S.F
Edit).
• Turn off the deck or eject the MD.
• Disconnect the AC power cord.
1
While the deck is stopped, playing, or
paused, press MENU/NO.
"Edit Menu" appears in the display.
2
Turn AMS (or press ./>
repeatedly) until "Undo?" appears.
"Undo?" does not appear if no editing has
been done.
3
Press AMS or YES.
One of the messages appears depending on
the last edit operation.
4
Press AMS or YES.
"Complete!" appears.