Panasonic Attune WX-C3010 Installation Instructions Manual page 15

1.Battery Lock [EJECT]
When removing the battery, slide out the lock. When
loading a battery, insert the battery until the lock clicks.
Please note the direction that inserts the battery.
2.Talk 1 Button [T1]
This button controls communications with (to) the
customer. When the button is released, you can hear
any customer who is at the menu-board. While the
button is held down in the Press-To-Talk mode, you can
speak to the customer. When the button is pressed in
the Talk-Lock mode, you can speak to the customer
until you press the button a second time.
3. Talk 2 / A/B Lane Selection Button [T2, A/B]
This button can be set to two functions by the DIP switch
setting. Refer to P.14 "DIP Switch Setup".
[T2]
This button controls communications with the customer
on Lane B of double-drive-thrus. When the button is
released, you can hear any customer who is at the
menu board. While the button is held down in the
Press-To-Talk mode, you can speak to the customer
who is at the menu board. When the button is pressed in
the Talk-Lock mode, you can speak to the customer
until you press the button a second time.
[A/B]
This button switches from Lane A to B and vice versa.
The lane indicator 8 displays the selected lane in yellow
(A) or green (B).
4.Page Button [P]
This button controls communications with store
personnel. When the button is released, you can hear
the communications among store personnel. While the
button is held down in the Press-To-Page mode, you
can speak to store personnel. When the button is
pressed in the Page-Lock mode, you can speak to the
store personnel until you press the button a second
time. (page lock is an option)
5.Optional Function Button [R]
This button is intended for functional extension. When
the Order Taker is set in the manager mode and this
button is pressed, operation cannot be forwarded for
talking or paging. At that time, the Telephone Indicator
of the Center Module lights. To recover the talk or page
operation, press this button again. The Telephone
Indicator is turned OFF and the talk and page operation
becomes possible.
6.External Device Control Button [C]
Press and hold the C button to turn on the external
device. (requires additional user circuitry)
7.Power Indicator
The indicator shows the status as follows.
Green: Power is supplied, and the unit is operating.
Green blinking: Power is supplied and Manager mode
is activated.
Red: The battery requires recharging.
Red blinking: ID is not registered, or the center module
is set to the ID Registration mode.
8.Lane Indicator
Lights yellow or green to indicate which the lane is in
operation.
Yellow: Lane A is selected.
Green: Lane B is selected.
Yellow blinking: Lane A is being selected, and either
the Talk or Page mode is activated.
Green blinking: Lane B is being selected, and either the
Talk or Page mode is activated.
9.Volume Control Buttons [VOL, +/– ]
Pressing the respective buttons will increase or
decrease the sound level. Audio level beeps will be
heard corresponding with the level.
10.Power Button [POWER]
Pressing the button will turn the Order Taker on.
Pressing the button again for 2 seconds or more will turn
the Order Taker off.
11.Earphone Output Jack
This jack is used for connection with the Panasonic
WXH3027 Headset.
12.Microphone Input Jack
This jack is used for connection with the Panasonic
WXH3027 Headset.
13.Switch Compartment
Do not open the cover of this compartment. Only
qualified service personnel or system installers should
open it.
14.Battery (Optional accessory)