Installing An Sd Card; Replacing The Battery (Battery Warm Swap) - Panasonic Toughbook FZ-T1 Series Operating Instructions Manual

Getting started

Installing an SD card

•
When installing or removing an SD card, place the unit on a flat surface.
•
If a battery is installed, remove it (page 12).
1.
Open the card slot cover (
•
Install only microSD cards.
•
Hold the microSD card so that the metal terminals are facing down, and insert with the notch facing
in the same direction of the circled area in the illustration below.
2.
Slide the microSD card until you hear a click.
•
To remove a microSD card, push it slightly into the slot to eject it.
3.
Close the card slot cover until you hear a click.

Replacing the battery (Battery warm swap)

You can replace the battery without turning the unit off.
•
Replace the battery within 30 seconds. If more than 30 seconds has passed, apps that are running are
forced to close and you may lose unsaved data.
•
During warm swapping, all wireless functions are turned off temporarily.
1.
Press and hold
Warm Swap].
•
You can also operate from [Warm Swap] in the app list.
2.
Follow the on-screen instructions.
•
It may take some time until the indicator turns off.
3.
Replace the battery.
IMPORTANT
•
Make sure the unit is not accessing the microSD card or SIM card before warm swapping the battery.
•
Do not remove the SD card or SIM card while warm swapping the battery.
•
Make sure you save any important data before warm swapping the battery.
14 Operating Instructions - Reference Manual
), and then insert the microSD card into the microSD card slot (
(power button) until the power options dialog is displayed, and then tap [Battery
).