Advertisement
WORKING INSTRUCTIONS
Never reach into the danger area of the plane when it
is running.
Place the front side of the product on to the workpiece
and switch on, before the planer blade touches the
workpiece and then guide evenly over the workpiece.
The v-shape notch in the front of the supporting plate
ensures safe chamfering of edges.
MAINS CONNECTION
Connect only to a single-phase AC current supply and
only to the mains voltage specified on the rating plate.
Must only be used from sockets with earth wire.
Appliances used at many diff erent locations including
wet room and open air must be connected via a
residual current device (FI, RCD, PRO) of 30mA or less.
Keep mains lead clear from working range of the
machine. Always lead the cable away behind you.
MAINTENANCE
The ventilation slots of the machine must be kept clear
at all times.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
service centre to avoid a safety hazard. Contact
authorised service centre.
Important note! If the carbon brushes are worn, In
addition to exchanging the brushes the tool should be
sent to after-sales service. This will ensure long service
life and top performance.
Use only AEG accessories and spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the machine type printed as well as the
six-digit No. on the label and order the drawing at your
local service agents or directly at:
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel. no. 0800 234 797
New Zealand
SYMBOLS
Please read the instructions carefully before
starting the machine.
CAUTION! WARNING! DANGER!
Always disconnect the plug from the
socket before carrying out any work on the
machine.
Accessory - Not included in standard
equipment, available as an accessory.
Rotation direction
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the
end of their life must be collected separately
and returned to an environmentally
compatible recycling facility.
Class II tool. Tool in which protection
against electric shock does not rely on basic
insulation only, but in which additional safety
precautions, such as double insulation or
reinforced insulation, are provided. There
being no provision for protective earthing or
reliance upon installation conditions.
Regulatory Compliance Mark (RCM).Product
meets applicable regulatory requirements.
13
13
13
Advertisement
