Maintenance And Warranty; Self-Diagnostic Test; Warranty - Epson S5U1C63000H6 Manual

Cmos 4-bit single chip microcomputer (s1c63 family in-circuit emulator)

Table of Contents

8 Maintenance and Warranty

The self-diagnostic test is executed by starting the debugger after setting the DIAG switch on the front panel to "ON"

position and then turning the S5U1C63000H6 on.

The debugger displays the messages shown below during the start-up sequence.

Debugger for S1C63 Ver. x.xx

Connecting USB ... done

DIAG test, please wait 1 min ... done

Parameter file name

Version

Chip name

CPU version

PRC board version

LCD board version

EXT board version

ICE hardware version

ICE software version

DIAG test

Map ............................. done

Initialize ...................... done

When an error is detected in the diagnosis, the error message is displayed at the point <1> instead of "done."

If an error message is displayed, stop using the S5U1C63000H6, as it may have a hardware failure.

This self-diagnostic test takes about one minute for its precise inspection until it is completed and the

S5U1C63000H6 is ready to accept commands.

Please refer to the warranty card included in the package for the warranty details.

S5U1C63000H6 ManUal

(S1C63 Family In-Circuit Emulator)

← <1>

: Par63xxx.par

: xx

: xxxxx

: x.x

: OK.

EPSOn

8 MaInTEnanCE anD WaRRanTY

Table of Contents