Appendix C. Programming with PanaView
C.5
Editing Meter Properties (cont.)
The window appears similar to Figure 26. To perform a specific task, refer to the appropriate section on the following
pages.
•
Setting the Meter Clock (page 107)
•
Reading Transducer Signals (page 108)
•
Plotting Transducer Signals (page 109)
•
Saving Transducer Signals (page 109)
•
Clearing Totalizers (page 109)
•
Handling Site Files (page 110)
Note: For illustration purposes, the meter shown here is a one-channel GX868 flowmeter. Specific parameters will
vary with your particular meter.
106
Figure 26: Properties Window for IDM-Based Meter
DigitalFlow™ GF868 Programming Manual (2-Channel)