Troubleshooting And Explanations; Troubles And Solutions; While Playing - Sony MZ-NE410 Notes on installing & operating OpenMG Operating Instructions Manual

Troubleshooting and explanations

Troubles and solutions

If you find any troubles operating the recorder, follow the steps below.
1
Check this section, "Troubles and solutions" (page 29).
2
If you cannot solve the problem after you made checks, consult your nearest Sony
dealer.

While playing

Symptom
An MD is not
played normally.
An MD is not
played from the
first track.
The digital sound
preset function
does not work.
Playback sound
skips.
Sound has a lot of
static.
Noise is
momentarily
heard.
Volume cannot be
turned up.
Cause/Remedy
• Repeat play is selected.
, Use MENU on the recorder to change back to the normal play
(page 18).
• Playback mode is changed.
, Use MENU on the recorder to change back to the normal play
(page 18).
• Disc playing stopped before it came to the last track.
, Press NX for 2 seconds or more to start playing.
• Group play mode is selected.
, Use MENU on the recorder to change back to the normal play
(page 18), and then press NX for 2 seconds or more to start
playing.
• The digital sound preset is off.
, Select "SOUND1" or "SOUND2" (page 19).
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a track under one second long.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• The sound was recorded in LP4 stereo mode.
, Because of the nature of the compression method used in LP4
mode, noise may be output on very rare occasions during
playback of sound recorded in this mode.
• AVLS is on.
, Release AVLS settings (page 25).
29