Functions And Operations - Hitachi KP-FD140GV Operation Manual

Functions and operations

Various mode setup and adjustment of KP-FD140GV/F140GV/FD83GV/F83GV/FD33GV/F33GV are performed by the remote
control via Gigabit Ethernet. Operation and adjustment way of function utilized are described below.
(Standard) means the function based on GenICam Standard Feature Naming Convention (SFNC) and (Custom) means the
original function. The software for GenICam can operate by using command name. Moreover, it can also be operated by reading
/writing the value to address directly.
1. Commands for acquisition
(1) ACQUITION ： Setting for image acquisition method
・MODE ： Select of mode
Command name
Address
Values (Factory setting 1) ： 1 "Continuous" Frames are captured continuously until stopped with the STOP command.
・START ： Acquisition start
Command name
Address
Values (write only)
・STOP ： Acquisition stop
Command name
Address
Values (write only)
・FRAME COUNT ： Set the number of capture
Command name
Address
Values (Factory setting 1) ： 1 to 255
・FRAMERATE RAW ： Acquisition frame rate
Command name
Address
Values (Factory setting 30: KP-FD140GV/F140GV
： AcquitionMode (Standard)
： A0030000 h
2 "MultiFrame" The number of frames specified by FRAME COUNT is captured.
3 "SingleFrame" One frame is captured.
： AcquiationStart (Standard)
： A0030004 h
： 1 Start the acquisition of the camera image.
： AcquitionStop (Standard)
： A0030008 h
： 0 Stop the acquisition of he camera image.
： AcquitionFrameCount (Standard)
： A003000C h
Set the number of frames to be acquired in MultiFrame mode.
： AcquitionFrameRateRaw (Standard)
： A0030014 h
36: KP-FD83GV/F83GV
90: KP-FD33GV/F33GV)
： 7 to 30: KP-FD140GV/F140GV
7 to 36: KP-FD83GV/F83GV
7 to 90: KP-FD33GV/F33GV
* Refer to page 19 "Frame rate"
*using when MODE is MultiFrame
Control the Frame rate in 1 fps step.
TM
GENiCAM is a trademark of EMVA (European Machine Vision Association).
6