Get/Set Of Mib; Send Trap; User Application (Log); Snmpv3 - NEC iPASOLINK EX Advanced Instruction Manual

SECURITY MANAGEMENT
3.1.2.1
iPASOLINK responds to the request of the network management system.
Up to ten SNMP managers including the setting of IP address, community name,
security settings, etc., can be registered via
By default, iPASOLINK uses the port 161 to receive the SNMP request UDP. To use
other than the default port, change the settings via
Item
GetRequest
GetNextRequest
Response
SetRequest
SNMPv2-Trap
GetBulkRequest
InformRequest
3.1.2.2
iPASOLINK can send SNMPv2 trap and InformRequest initiatively to UDP port 162.
Except for sending the trap to the connected NMS, user can specify an IP address of
one additional destination. User can also specify the community name and UDP Port.
3.1.2.3
iPASOLINK records the logged-in user name in the log file.

3.1.3 SNMPv3

SNMPv3 (Simple Network Management Protocol Version 3) is a communication
protocol to monitor/control NEs on an IP network, and is the newest version of
SNMP. The differences between SNMPv1/v2c and v3 are that the user authentication,
ciphered communication, and the change-packet format are enhanced, conforming to
the following RFCs for SMIv2 that define SNMPv3, SNMPv2c:
iPASOLINK EX Advanced: S

GET/SET of MIB

Table 3-4 PDU Supported by SNMPv2c
Description
Requests the specified instance value.
Requests the subsequent instance value of specified instance value in the
list.
Responds to the corresponding various kinds of Request.
Sets the specified instance value.
Informs the change of state and troubles. The format is different from
SNMP v1 trap.
Requests a number of instance value.
Informs an event.

Send Trap

User Application (Log)

N S P
ET ETWORK AND YSTEM
WebLCT
ROVISIONING
.
.
WebLCT
GGS-000547-01E
3-3