Instructing In Using The Panel - Hitachi SJ700D-3 SERIES Quick Reference Manual

Hide thumbs Also See for SJ700D-3 SERIES:
Table of Contents

Advertisement

S.2 Instructing in using the panel
This section describes how to use the operator to
change the settings.
For more information, refer to the SJ700D-3 manual or
section 3.2 : How to operate the Digital Operator.
Indication of using the control panel
Key
Display(Example)
Operation
d001 ←→ 0.00
(Frequency monitor)
A--- → A044
FUNC
A044 ← 00
(Control mode)
STR
(Control mode)
d001→d002→...
→F004→A---→...
1
1.00→1.01→...
A011→A012→...
A---→F004→...→
d002→d001→...
2
1.01→1.00→...
A012→A011→...
A044→'A'044
1
2
Simultaneously
0.00→'0'.00
*) In some cases parameters and data are discontinuous.
(For more information, refer to SJ700D-3 manual.)
Use examples (*** is a three digit number)
In case d*** or F*** display on the panel, indication changes
between parameters and data with pushing FUNC key.
In case A***, B***, C***, H***, P*** or U*** display on the
panel, indication changes among A--- (head of group), A044
(parameter) and 00 (data) with pushing FUNC key.
When the panel indication displays 00 (data), the inverter saves the
00 → A044
displayed value as the new setting with pushing the STR key, and
panel indication changes to the A044 (parameter). The saved data
are held even if the power supply to the inverter is turned off.
Panel Indication scrolls up through d***, F*** and the heads of
group (for example A---, B---, C---, H---, P--- and U---).
The value increases if panel indication displays parameters or data.
Holding the key down changes the value faster.
Panel indication scrolls down through d***, F*** and the heads of
group (for example A---, B---, C---, H---, P--- and U---).
The value decreases if panel indication displays parameters or data.
Holding the key down changes the value faster.
Pushing simultaneously enables to change each digit directly.
Operating of
the blinking digit is as follows.
Start-up
RUN
PRG
RUN
FUNC
Standard Operator (OPE-SBK)
Left
FUNC
S - 3
Commissioning the drive
POWER
ALARM
Hz
V
A
%
STOP/
RESET
STR
1
2
Increasing
1
Right/Save
STR
2
Decreasing
kW

Advertisement

Table of Contents
loading

Table of Contents