Advertisement
Quick Links
STACKING KIT INSTALLATION INSTRUCTIONS
WARNING :
This kit is not to be used for stacking a gas
dryer. Additional gas hook-up components are required.
Caution : Two people are required to lift the dryer on to the washer.
Dryer
Step 1: Place cover (cloth, cardboard, or carpeting) on floor surface
to avoid damage.
Step 2: Lay the dryer on its side (not front or back).
Step 3: Unscrew and disassemble the four leg
assemblies.
Step 4: Disassemble each leg from the bracket. Then flip
the bracket over and remount onto the leg.
Step 5: Reassemble each leg and bracket into the dryer base.
(MAH6700 washer & MDE6700 dryer only)
Hook
Step 6: Snap the Stacking Support Guides into the rectangular holes
in the dryer base and secure each with two(2) Screws Phillips-pan
head (6006-001174).
Step 7: Bottom view of the dryer after assembling the Stacking
Support Guides to the dryer base.
DC68-01052D REV(0.1)
Advertisement
Summary of Contents for Maytag Stacking kit
- Page 1 STACKING KIT INSTALLATION INSTRUCTIONS (MAH6700 washer & MDE6700 dryer only) WARNING : This kit is not to be used for stacking a gas dryer. Additional gas hook-up components are required. Caution : Two people are required to lift the dryer on to the washer.
- Page 2 STACKING KIT INSTALLATION INSTRUCTIONS (MAH6700 washer & MDE6700 dryer only) Washer Step8 : Assemble the Rear Brackets to the washer as Step10 : Assemble the Rear Brackets to the dryer as shown shown above. Use two(2) Screws-Hex above. Note that four screws must be used to hold the Rear Head(34001382) with washers in each washing machine Brackets to the back of the dryer.