Installation Instructions - Zanussi ZEV8646XBA User Manual

Installation instructions

Before the installation, note down the
serial number (Ser. Nr.) from the rating
plate.The rating plate of the appliance is
on its lower casing.
ZEV8646XBA
220-240 V 50-60 Hz
58 HBD 47 AO
ZANUSSI
The Safety Instructions
Warning! You must read these!
• Make sure that the appliance is not damaged
because of transportation. Do not connect a
damaged appliance. If it is necessary, speak
to the supplier.
• Only an authorized servicing technician can
install, connect or repair this appliance. Use
only original spare parts.
• Only use the built-in appliances after you as-
semble the appliance into correct built-in
units and work surfaces that align to the
standards.
• Do not change the specifications or change
this product. Risk of injury and damage to the
appliance.
• Fully obey the laws, ordinances, directives
and standards in force in the country where
you use the appliance (safety regulations, re-
cycling regulations, electrical safety rules
etc.)!
• Keep the minimum distances to other appli-
ances and units!
• Install shock protection, for example install
the drawers only with a protective floor di-
rectly below the appliance!
• Keep safe the cut surfaces of the worktop
from moisture with a correct sealant!
www.zanussi.com
• Seal the appliance to the work top with no
space between with a correct sealant!
• Keep safe the bottom of the appliance from
steam and moisture, e.g. from a dishwasher
or oven!
949 595 525 00
• Do not install the appliance adjacent to
doors and below windows! If not, when you
7 kW
open the doors or windows they can push off
hot cookware from the appliance.
electrical connections.
• The electrical mains terminal is live.
• Make electrical mains terminal free of volt-
age.
• Install correctly to give shock protection.
• Loose and incorrect plug and socket con-
nections can make the terminal become too
hot.
• A qualified electrician must install the con-
nections in the clamps correctly.
• Use a strain relief clamp on cable.
• Use the correct mains cable of type H05BB-
F Tmax 90°C (or higher) for a single phase or
two phase connection.
• Replace the damaged mains cable with a
special cable (type H05BB-F Tmax 90°C; or
higher). Speak to your local Service Centre.
The appliance must have the electrical installa-
tion which lets you disconnect the appliance
from the mains at all poles with a contact open-
ing width of minimum 3 mm.
You must have correct devices to isolate: line
protecting cut-outs, fuses (screw type fuses re-
moved from the holder), earth leakage trips and
contactors.
Warning! Risk of injury from electrical
current. Carefully obey the instructions for
3