Sony Handycam DCR-VX2100E Operating Instructions Manual page 136

Inserting a scene from a VCR
– Insert editing
To change the insert end point
Press ZERO SET MEMORY on the Remote
Commander again after step 5 to erase the
ZERO SET MEMORY indicator and begin from
step 3.
Using the Remote Commander
In step 5, press z REC and MARK
simultaneously, then immediately press X.
And in step 6, press X at the scene from which
you want to start recording.
Note
The picture and sound recorded on the portion
between the insert start and end points will be
erased when you insert the new scene.
If you insert scenes on the tape recorded
with an other camcorder (including an other
DCR-VX2100E)
The picture and sound may be distorted. We
recommend that you insert scenes on a tape
recorded with your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the
end of the inserted portion. This is not a
malfunction.
The picture and sound at the start point and
the end point may be distorted in the LP mode.
To insert a scene without setting the insert
end point
Skip steps 3 and 4. Press x when you want to
stop inserting.
136
z
X
X
x