Light Switch On / Off; Set The Unit Of Pressure (Psi, Bar Or Kpa); Tire Pressure Check; Tire Pressure Increase / Decrease - AEG KD 7.0 Operation And Safety Notes

Operation
j 
C arry out the desired work procedures as
described in following chapters.
j 
S witch on the compressor by pressing the
ON-/ OFF switch
3
j 
S witch off the compressor by pressing the
ON-/ OFF switch
3
j 
P ull the 12 V vehicle connection
12 V-socket of the vehicle.

Light switch ON / OFF


The light source on the compressor is intended
to better illuminate the working area (valve)
j 
P ress the ON-/OFF –switch Light
position , to switch on the 3 LED
j 
P ress the ON-/OFF –switch Light
position , to switch off the 3 LED
Set the unit of pressure
 
(psi, bar or kPa)
j 
P ress the button Pressure unit „R"
the desired pressure unit is shown on the
manometer display

Tire pressure check


j 
U nwind the high-pressure hose
pletely.
note: Make sure that the power LED at the
12 V vehicle connection
manometer display
before beginning of the measurement.
j 
F ix the valve connection
the vehicle.
If the valve connection
ed with the vehicle valve, the manometer
display shows the current tire pressure.
2
j 
I f this value corresponds to the recommend-
ed tire pressure for the vehicle, you can
remove the valve connection
14 GB
into the position .
into the position .
from the
10
into
16
.
14
into
16
.
14
until
1
.
2
com-
13
lights up. The
10
must indicate 0,0
2
on the valve of
15
is correctly connect-
15
again.
15

Tire pressure increase / decrease


If the indicated value lies under or over the rec-
ommended tire pressure for the vehicle, proceed
for adjustment as follows:
j 
P ress the button pre-setting „+ "
tively the button pre-setting „- "
pre-set value of the manometer display
corresponds to the correct tire pressure.
j 
S witch on the compressor by pressing the
ON- /OFF- switch into position . The device
increases respectively decreases the tire
pressure according to the pre-set value and
switches off automatically.
j 
R emove the valve connection
Important:
j 
D uring the pumping procedure do not press
the buttons or
4
j 
I f you connect the device to the 12 V-supply
of a vehicle but do not start the pumping
procedure, the manometer display
switches off after some minutes. You acti-
vate it again, by pressing the button unit of
pressure „R " .
1

Use delivered valves


In the stowage box cover
there are 3 typical valve adapters.
Always consider the manual of the object which
is to be pumped up.
· Racing cycle valve (Presta valve)
· Valve for sport balls
· Valve for inflatable toy
j 
S crew the desired valve on the valve con-
nection . Consider the corresponding
15
maximum pressure of the object which is to
be pumped up and read the respective
operating manual.
respec-
5
until the
4
2
carefully.
15
.
5
2
of the compressor
6
7
8
9