ECC800 Data Center Controller
User Manual
Button
Name
Default
Communications Ports
The ECC800 provides the following communications ports. Figure 3-4 shows the pins of the
RJ45 port.
Figure 3-4 RJ45 port pins
There are four FE ports, that is, two WAN ports (WAN_1 and WAN_2) and two LAN ports
(LAN_1 and LAN_2). Table 3-8 provides the FE port pin definitions.
Table 3-8 FE port pin definitions
Item
Pin sequence
Issue 02 (2019-02-28)
Function
Operation Description
Description
WiFi pairing
In non-WiFi pairing mode, press the
button
button for less than 1.2s to enter the
WiFi pairing mode.
NOTE
This function is
supported only
in a scenario
where the WiFi
converter is
configured.
IP address reset
Press and hold down the button for
3s. Then the IP address for the
ECC800 WAN_1 port will restore
to the default address 192.168.1.10.
Description
Pin 1
TX+
Copyright © Huawei Technologies Co., Ltd.
3 Device Description
Indicator Status
When the system
enters the pairing
mode, the RUN
indicator is
steady on.
After pairing
succeeds, the
RUN indicator
blinks just as
before WiFi
pairing.
If pairing does
not succeed in 3
minutes, the RUN
indicator blinks
just as before
WiFi pairing.
None
16