Advertisement
blood circulation.
■ Take frequent work breaks. Limit the amount of
exposure per day.
If you experience any of the symptoms of this
condition, immediately discontinue use and see your
doctor about these symptoms.
SPECIFIED CONDITIONS OF USE
The pneumatic hammer can be universally used for
hammer drilling and chiselling in stone and concrete.
Do not use this product in any other way as stated for
normal use.
MAINS CONNECTION
Connect only to single-phase AC system voltage as
indicated on the rating plate. It is also possible to
connect to sockets without an earthing contact as the
design conforms to safety class II.
Appliances used at many different locations including
wet room and open air must be connected via a
residual current device (FI, RCD, PRCD) of 30mA or
less.
Only plug-in when machine is switched off.
MAINTENANCE
The ventilation slots of the machine must be kept clear
at all times.
If the power supply cord is damaged, it must be
replaced only by the manufacturer or by an authorised
service centre to avoid a safety hazard. Contact
authorised service centre.
Use only AEG accessories and AEG spare parts. Should
components need to be replaced which have not been
described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered.
Please state the machine type printed as well as the
10-digit No. on the label and order the drawing at your
local service agents.
If needed, an exploded view of the tool can be ordered.
Please state the machine type printed as well as the
six-digit No. on the label and order the drawing at your
local service agents or directly at:
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Australia
Techtronic Industries N.Z. Limited
PO Box 12-806
Penrose AUCKLAND 1642
Tel. no. 0800 234 797
New Zealand
10
10
SYMBOLS
CAUTION! WARNING! DANGER!
Always disconnect the plug from the
socket before carrying out any work
on the machine.
Please read the instructions carefully
before starting the machine.
Parts or accessories sold separately
Do not dispose of electric tools
together with household waste
material. Electric tools and electronic
equipment
the end of their life must be
collected separately and returned
to an environmentally compatible
recycling facility.
Class II tool. Tool in which protection
against electric shock does not rely
on basic insulation only, but in which
additional safety precautions, such
as double insulation or reinforced
insulation, are provided. There
being no provision for protective
earthing or reliance upon installation
conditions.
Regulatory Compliance Mark (RCM).
Product meets applicable regulatory
requirements.
that
have
reached
Advertisement
