Panasonic LP-V Series Operation And Maintenance Manual page 181

Description
6 Bold Line Width :
Specifies the width of bold character line.
0.000 to 2.000 mm
Setting Range 0.000 to 4.000 mm
0.000 to 6.000 mm
Notice
• Marking of bold character may affect the quality of marking. Check it by a trial before using this function.
Reference
• At marking of bold characters, set the values so ratio of character height to character width be within 1/4 to 4.
• Set line width of bold character to quarter or below of either smaller one, character height or character width.
• When marking the bold character, set the marking pitch in the Laser Condition together. Refer to "4-11 Laser Setting"
(P.214).
• The Original Font 4 may fail to mark the character in bold.
7 Laser Power Correction :
Scan Speed Correction :
Laser Pulse Cycle Correction (Only LP-V series) :
Correction of each character condition No. for the laser power / scan speed / laser pulse cycle set at laser setting.
Setting Range of Laser Power Correction
Setting Range of Scan Speed Correction
Setting Range of Laser Pulse Cycle Correction
Reference
• If the value of "Laser power correction" × "laser power" is equal to or larger than 100, the setting will be "100".
• Marking is not available when the laser power correction value is "0".
• If the corrected value exceeds the setting limit, the nearest upper or lower limit value of the each item is set.
8 Area No. :
Displayed when marking on-the-fly is set in "Trigger setting".
It indicates the order of the marking field for the concatenated marking to flying object.
Setting Range 0 to 15
(LP-V10 / LP-W052)
(LP-431 / LP-421 / LP-411 / LP-V15)
(LP-430 / LP-420 / LP-410 / LP-435 / LP-425)
0 to 200%
5 to 500%
50 to 200%
ME-LP400V-OP-6
181