Optional Accessories; Removal And Installation Method Of Battery; Charging Method - Hitachi NR 1890DC Instruction And Safety Manual

Cordless strip nailer
Hide thumbs Also See for NR 1890DC:
Table of Contents

Advertisement

Available languages

Available languages

English

OPTIONAL ACCESSORIES

sold separately
○ BATTERY (BSL1830C)
NOTE
Accessories are subject to change without any
obligation on the part of Hitachi.
APPLICATIONS
○ Floor and wall framing.
○ Truss build-up, Window build-up.
○ Subfl ooring and roof decking.
○ Wall sheathing.
○ Mobile home and modular housing construction.
REMOVAL AND INSTALLATION
METHOD OF BATTERY
CAUTION
● Be sure keep the fi ngers away from the trigger
and push lever away from the wood.
○ How to install the battery.
Align the battery with the groove in tool handle and
slip it into place.
Always insert it all the way until it locks in place with a
little click, If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
○ How to remove the battery.
Withdraw battery from the tool handle while pressing
the latch (2 pcs) of the battery.
Latch

CHARGING METHOD

NOTE
Before plugging into the receptacle, make sure the
following points.
○ The power source voltage is stated on the nameplate.
○ The cord is not damaged.
16
Handle
Battery
Push
Pull out
Insert
WARNING
Do not charge at voltage higher than indicated
on the nameplate.
If charged at voltage higher than indicated on
the nameplate, the charger will burn up.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals)
WARNING
Do not use the electrical cord
if damaged. Have it repaired
immediately.
2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in
the fi gure.
Pilot lamp
Charger
3. Charging
When the battery is connected to the battery charger,
charging will commence and the pilot lamp will light in
red. (See Table 2)
NOTE
If the pilot lamp fl ikers in red, pull out the plug from
the receptacle and check if the battery is properly
mounted.
When the battery is fully charged, the pilot lamp
will blink in red slowly. (At 1-second intervals) (See
Table 2)
Battery

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nr 1890dr

Table of Contents