Get Started; Charge Power; Install Remote Control Battery - Philips PV7005 User Manual

3 Get started

Always follow the instructions in this chapter in
sequence.

Charge power

The player has a built-in battery that can be
charged through the USB port of a computer.
1
Connect the player to a PC with the
supplied USB cable.
Tip
‡
To complete recharging in a shorter period, connect
both of the USB connectors to the USB ports of your
computer.
» You are prompted to select:
: To transfer data to PC through the USB
&
connection and charge the battery.
7R SOD\ PHGLD ÀOHV IURP WKLV SOD\HU DQG
&
charge the battery.
1
Tap or .
&
&
» The charging animation is displayed.
Note
‡
If no selection is made in 10 seconds, the player
automatically applies (power charging and data
&
transfer).
All manuals and user guides at all-guides.com
1 2
2
When the charging animation stops and
the icon is displayed, the charging
process is completed.
Note
‡
Rechargeable batteries have a limited number of charge
cycles. Battery life and number of charge cycles vary by
use and settings.
Battery level indication
The player shows the approximate battery level:
100% 75% 50%
:KHQ WKH EDWWHU\ LV ÁDW WKH EDWWHU\ ÁDVKHV 7KH
player saves all settings and switches off within
10 minutes.
Tip
‡
To conserve battery power and increase the play time,
set the backlight timer to a low value (go to
[Backlight time].

Install remote control battery

Caution
‡
Risk of explosion! Keep batteries away from heat,
VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH
‡
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
‡
Batteries contain chemical substances, they should be
disposed of properly.
)RU ÀUVWWLPH XVH
Remove the protective tab to activate the
remote control battery.
25% 0%
> >
EN 11