Panasonic FP2 User Manual page 37

FP2 Serial Data Unit
Explanation of the bits
If the power supply is turned on with the factory settings still in effect, the status of the
bits in the transmission format address section (COM.1 1003 and COM.2 1004) in the
shared memory is as follows: 0000 0001 0001 1010 = H011A.
Bit status with the factory settings
15
Bit No.
0
Setting contents
BCD H code
To set the control signals CS and CD valid from the factory setting state, first turn bit 7
on, and then set the bit status to 0000 0001 1001 1010. This writes "H 019A" in the
program above to the shared memory.
Bit status when control signals CS and CD are valid
15
Bit No.
0
Setting contents
BCD H code
3.2 Setting the Transmission Speed and Transmission Format
14 13 12 11 10
0 0 0 0 0
0 1
14 13 12 11 10
0 0 0 0 0
0 1
Start code
End code
Control signals CS and CD
Confirming the Unit Settings and Design Contents
9 8 7 6 5
0 1 0 0 0
1
9 8 7 6 5
0 1 1 0 0
9
Stop bit
Parity check
Data length
Transmission speed
4 3 2 1 0
1 1 0 1 0
A
4 3 2 1 0
1 1 0 1 0
A
3 − 9