Windscreen Wipers/Washers; Wipers And Washers - Honda CR-V 2019 Owner's Manual

Wipers and Washers

■

Windscreen Wipers/Washers

Pull to
use
washer.
Intermittent Time
Adjustment Ring *
MIST
OFF
INT *2 /AUTO *3
LO: Low speed wipe
HI: High speed wipe
*1: Models with the keyless access system have an ENGINE START/STOP button instead of an
ignition switch.
*2: Models with manual intermittent operation
*3: Models with automatic intermittent operation
* Not available on all models
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windscreen wipers and washers can be
used when the ignition switch is in ON
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT *2 /AUTO
HI)
Change the wiper switch setting according to
the amount of rain.
■
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
■
Washer
Sprays while you pull the lever towards you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windscreen,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windscreen is dry.
( w *1 .
The windscreen will get scratched, or the rubber
blades will get damaged.
NOTICE
*3 , LO,
In cold weather, the blades may freeze to the
windscreen.
Operating the wipers in this condition may damage
the wipers. Use the demister to warm the
windscreen, then turn the wipers on.
NOTICE
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
Models with intermittent time adjustment ring
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting (
the same.
If the wiper stops operating due to an obstacle such
as the build-up of snow, park the vehicle in a safe
place. Rotate the wiper switch to OFF, and turn the
ignition switch to ACCESSORY
then remove the obstacle.
Continued
) and the LO setting become
or LOCK *1 ,
q ( 0 (
233