Makita BR400MP Original Instruction Manual page 8

7. Tighten 3 screws on the gear case.
► 1. Screw 2. Gear case
8. Tighten 2 screws on the protector.
► 1. Screw 2. Protector 3. Sleeve 4. Gear case
NOTICE:
Make sure that there is no gap
between the gear case and the sleeve, and the
sleeve and the protector.
9. Attach the brush or sweep drum to the brush unit
or sweep drum unit, and then attach the clip to the
brush or sweep drum.
NOTICE:
sure to attach them with the Makita logo facing
1
outside.
NOTICE:
sure to attach them in the direction shown in the
figure, so that the sweep drums and the gear case
mesh with each other.
2
1
2
3
4
► 1. Sweep drum 2. Gear case
Mounting the attachment pipe
CAUTION:
ment pipe is secured after installation. Improper
installation may cause the attachment falling off from
the power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1. Turn the lever toward the attachment.
► 1. Lever
8 ENGLISH
When attaching the brushes, be
When attaching the sweep drums, be
1
Always check that the attach-
2
1