Cutting The Printed Paper - Sony UP-X898MD Instructions For Use Manual

Starting a Print Job
1
Press the power ON/OFF switch to on.
The back light on the LCD lights in green, and
"READY" is displayed on the LCD.
LCD
2
Operate the computer by using the application
software.
When the message is displayed on the LCD
If a problem occurs, the back light on the LCD lights in
orange and the error message stating the problem is
displayed on the LCD.
Message Cause and remedy
EMPTY:XX Paper is not loaded. Load paper.
DOOR:XX The door is open. Close the door.
XX indicates the selected paper.
"S" means UPP-110S, "HD" means UPP-110HD, and
"HG" means UPP-110HG.
When the unit stops printing during printing
When printing almost black images continuously, the
thermal head protection circuit may shut down the unit
to prevent the thermal head from overheating. In such a
case, the message "COOLING" is displayed on the
LCD.
Leave the unit until the head cools down and this
message disappears.
Paper currently selected
You can check the paper type currently selected on the
LCD. The paper type currently selected is displayed on
the right edge of the LCD when you press the OPEN
button and open the door panel.
28
Printing
UPP-110S
UPP-110HD
UPP-110HG

Cutting the Printed Paper

Cutting using the upper paper cutter
Hold the edge of the paper and cut the paper upward in
an arc.
Cutting using the lower paper cutter
Hold the corner of the paper and pull downward at an
angle to cut the paper.
Notes
• If you cut the paper by pulling it horizontally, the
paper inside the unit will skew and may cause
misprinting. If the paper is skewed, reload the paper
correctly. (page 15)