7
ONLINE MODULE CHANGE
(4) Operation check
7
7.3 Online Module Change Procedure
- 21
7.3.4 When user range setting is used and initial setting was made with GX Configurator-TI (other system
(a) To make an operation check, click the
resumption.
Figure 7.39 Cancel of control resumption
(b) Click the
Figure 7.40 "Online module change" mode stop
(c) Click the
Figure 7.41 "System Monitor" screen
(d) On the OMC refresh data screen of GX Configurator-TI, set the prerecorded
values and make a OMC refresh data write request. (Refer to Section 5.6.3.)
button to leave the "Online module change" mode.
button to close the System monitor screen.
button to cancel control