Projecting Image - JVC DLA-VS4010 Instructions Manual

Projecting Image

If setting for this projector is not completed, refer to "User Settings Menu"P. 34 upon turning on the power and configure
the settings accordingly.
Once the basic settings are configured, this projector can be used by simply performing the following operation
procedures.
Remove the lens cap.
0
Connect this projector to the computer. (P. 19, 21)
0
Connect the LAN cable. (P. 22)
0
Set this projector to the standby mode, and display the "Main" menu
1
Refer to "Turning On the Main Power"P. 24, and steps 4 to 6 of "Assigning a static IP address"P. 25.
0
The [STANDBY/ON] indicator lights up in red.
0
Click the "ON" button under the "Power" item of the "Main" menu to project the image
2
The power of this projector turns on, and formatting is done taking a few minutes. A gray image will be displayed
0
during formatting. The projected image appears once formatting ends.
The [STANDBY/ON] indicator lights up in green.
0
MEMO
You can also turn on the power by pressing the [OPERATE Z] button on the projector unit for more than one second.
0
The image may flicker for a few seconds immediately after projection starts. This is not a malfunction.
0
After the LD block lights up, it takes more than 1 minute for the brightness of the video image on the screen to
0
stabilize.
Power
Main
Image
ON OFF
Setting
Light Source Time
Convergence
10h59m
Lens
Option
License
Signal Status
DVI Rate(Hz) Pixel H
1 60.00 2048
2
3 60.00 2048
4
.
host PJ-1
user: root
Logout
Warning Status
PROJECTION None
Hide
OFF ON
Temperature
Exhaust
Pixel V Link
30.3 deg.C
2400 Dual
Intake
30.3 deg.C
2400 Dual
Inside
30.3 deg.C
29