NETGEAR MBR1515 User Manual page 47

Field
Firmware Version
Mobile Broadband Modem Identity
Modem sw version
Modem driver
version
IMSI
IMEI
Operator
Network mode
WAN Port Connection Status
IP Address
Protocol
IP Subnet Mask
Gateway IP Address The IP address used by the router.
Domain Name
Server
LAN Port MAC Address
IP Address
DHCP
IP Subnet Mask
Wireless Port Name (SSID)
(See Manually
Region
Configure Your
Wireless Settings on
Channel
page 27.
Wireless AP
Broadcast Name
LTE Broadband 11n Wireless Router MBR1515
Description
This field displays the router firmware version.
Shows the modem in use.
The software version of the modem.
The driver version of the modem.
International Mobile Subscriber Identity. SIM card identity.
International Mobile Equipment Identity.
Unique identity of the modem.
The ISP for the broadband wireless network.
The mode of the current network the modem is connected to.
This is dependent on coverage and distance from the cell site.
The status of the Internet connection.
The IP address used by the modem. If no address is shown,
the router cannot connect to the Internet.
The protocol for the Internet connection, which is PPP
(Point-to-Point).
The IP subnet mask used by the router's USB port.
The DNS server IP addresses used by the router. These
addresses are usually obtained dynamically from the ISP.
The Ethernet MAC address used by the router's LAN port.
The LAN port IP address. The default is 192.168.0.1.
• Off. The router does not assign IP addresses to PCs on
the LAN.
• On. The router assigns IP addresses to PCs on the LAN.
The LAN port IP subnet mask. The default is 255.255.255.0.
The service set ID, also known as the wireless network name.
The country where the unit is set up for use.
The current channel, which determines the operating
frequency.
Indicates if the access point feature is disabled or not. If not
enabled, the Wireless LED on the front panel will be off.
Indicates if the router is configured to broadcast its SSID.
Managing Your Network
47