Makita DBN500 Instruction Manual page 8

3
4
014585
Press the lock lever and open the slide door of the
magazine.
3
014592
Set the nail strip so that the nail tips touch the bottom of
the magazine slit and slide the nail strip toward the firing
opening.
Return the slide door to the original position until the
lock lever locks it.
To remove the nails, press the lock lever and slide the
slide door. Take out nails from the magazine slit.
Nose adapter
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger, and the battery cartridge and nails
are removed before installing the nose adapter.
3
2
1
014586
When firing nails on the material to be fastened with
easily-marred surfaces, use the nose adapter. To install
the nose adapter, place it over the center plate so that
the protrusion inside the nose adapter fits to the slit in
the driver guide cover.
When not in use, store the nose adapter in the holder at
the back end of the slide door to keep it from being lost.
Total two nose adapters can be stored.
1. Lock lever
2. Slide door
1
3. Driver guide
4. Magazine
2
1. Nails
2. Slide door
3. Driver guide
2
1
1. Nose adapter
2. Protrusion
3. Center plate
4. Holder
4
Hook
CAUTION:
Always make sure that your fingers are not placed
•
on the trigger, and the battery cartridge and nails
are removed before using the hook.
Do not hang the hook from the waist belt.
•
Dropping the nailer, which is caused by the hook
accidentally coming out of place, may cause
misfiring and personal injuries.
014587
1
2
014588
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Hex wrench storage
014589
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
8
1. Groove
2. Hook
3. Screw
1. Hex wrench
1