General User Information; Washer Maintenance - Maytag MXR65 Service Manual

GeNeRal uSeR
iNFORMaTiON
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Disconnect the washer from the electrical
power source before removing any panels.
Before proceeding with disassembly, turn off
the water supply.
Sizes of hardware are provided in this manual
so the technician will know the tool size to
remove the hardware, not to identify the
thread size. For instance, if a procedure
describes a 24mm hex nut or a 24mm hex
head bolt, that description means a 24mm
socket or wrench will be needed.
In video clips and photographs in this
manual, parts may be removed that are not
necessary to be removed for the particular
procedure being described. Parts are not
replaced as video recording is done. Parts
may be removed to provide better viewing
of the procedure being shown. Refer to the
procedural steps in this service manual for the
correct list of parts that must be removed for
access to each component.

WaSHeR MaiNTeNaNCe

Maintenance Schedule
after each load
n Remove debris from the washer basket
including paper clips, coins, and other hard
items.
n When not in use, leave the washer door
open to allow the washer to air out and
prolong gasket life.
Daily Maintenance
n Clean water, detergent, and other stains off
of the washer with a soft cloth dampened
with a mild detergent solution.
n Dry with a soft cloth, not abrasives.
n Clean detergent residue and other
contamination off the door seal with a soft
cloth dampened only with a mild detergent
solution. Avoid using solvents or acids.
Avoid lubricating seal with oil or grease.
n Remove residue from the detergent hoppers
with a plastic scraper. Wipe the hoppers
with a soft cloth dampened with water.
n Check water inlets for leaks. Correct as
necessary.
n Check drain valve for leakage during a wash
cycle (the valve is in open position when
there is no electricity to it).
Maintenance every 200 Working
Hours or every Month
n Make sure external liquid soap supply
system is not leaking. Check all hose joints,
screw joints and all connections in the
system.
1-6