Advertisement
to re-enter bind mode, unscrew
the L506 from the fixture and then
screw it back in.
2.
On the e528, enter the Service
menu.
Press and hold the F° /C°
•
button
Press and release
•
OFF/AUTO
Press and release DISPLAY
•
Release F° /C°
•
3.
Use the UP or DOWN arrows to
go to the Address parameter
(ADR).
4.
Press DISPLAY. Use the
UP/DOWN arrows to enter the
ADR value from the
commissioning sheet.
5.
Press OFF/AUTO; a single beep
should sound.
6.
On the L506, press and hold the
built-in on/off button for 5 seconds.
The e528 will beep quickly 3 times
to confirm binding.
Operation
Besides being used in the binding
operation, the built-in button on the
L506 can control the lighting load.
Press and hold the button to adjust
lighting (dimming) levels up or down. A
quick press will turn the light off or on.
The L506 has a status indicator LED.
When the lamp is on, the LED is too.
Technical Specifications
Parameter
Rating
Power
110-120VAC, 50/60Hz
0.9A dimmable output
1.3W
Standby power
11mA
Standby current
Operating
0–25 C˚
Environment
Parameter
Rating
Dimensions:
63.3mm L × 47.3mm
W x 98mm H (with
socket)
FCC Part 15b, Class
Approvals
A, UL
FCC ID: GTC202516TXR
This device complies with part 15 of
the FCC Rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may
cause undesired operation.
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These
limits are designed to provide
reasonable protection against
harmful interference in a residential
installation. This equipment
generates, uses, and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation.
If
this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one of the
following measures:
—Reorient or relocate the receiving
antenna.
—Increase the separation between
the equipment and receiver.
—Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
—Consult the dealer or an
experienced radio/TV technician for
help.
Any changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
this equipment.
C ID: 1609A-202516TXR
This device complies with Industry
Canada license-exempt RSS
standard(s). Operation is subject to
the following two conditions: (1) this
device may not cause interference,
and (2) this device must accept any
interference, including interference
that may cause undesired operation
of the device.
Le présent appareil est conforme aux
www.inncom.com
2
Advertisement
