Samsung STAR C0640 User Manual

User Guide
SPECIFICATIONS
PRECAUTIONS
PREPARATION
STAR C0640
ELECTRICAL
Current dissipation: 110 mA (Colored: 76 mA)
Power Consumption: 1,08 W (Colored: 0,92 W)
Operating power : DC 12V
Maximum serial connection : 25 modules
Electronic dimming control supported
Constant current drive, Reverse voltage protection
PHYSICAL
Use precautions to avoid damages to the product or injuries of users. Any actions against following contents will cause serious
issues such as malfunction, electric shock, or burn.
DC12V
USE DC12V ONLY
AC INPUT
DO NOT USE AC INPUT
Do not cut or rejoion wires while product
is connected wth live power source
Avoid performing installation under rain or
high humidity for outdoor use
Do not use the product under circumstances
listed below
- High temperature spots over 60˚C (140˚F)
- Spots draw extreme moisture or dust
TOOLS REQUIRED
Wire Stripper, Drill, Screw Driver, Wiper
PREPARE CHANNELS
1. Clean moisture and dust inside
2. Make holes for wires from modules to SMPS.
3. Without bushins, wires will easily be cut and short-circuit will occur.
FARD lighting GmbH Seestrasse 20
Tel. +49 - (0)3378 / 2003-0
info@fard-lighting.de
THERMAL
Cooling : Ambient air
Maximum operating temperature : 60˚C (140˚F)
Minimum operating temperature : -25˚C (-13˚F)
Maximum storage temperature : 60˚C (140˚F)
Minimum storage temperature : -30 C (-22 F)
SUPPLIES REQUIRED
Wire Nuts, Cable Ties, IDC Connectors, VCTF(PLTC) Cable,
(Optional : Silicon and Screws)
2. Make holes
D - 14974 Ludwigsfelde OT Genshagen
Fax +49 - (0)3378 / 2003-29
www.fard-lighting.de
Do not perform actions listed below
- Alter or modify
- Touch LED lamps with sharp objects
- Put glue or silicon over the LED lamps
Maximum driver quantity per serial
connection is limited. Failure causes overload
of current and damages to the product
Refer to 'WIRE THICKNESS' table to use proper
LED module
Failure will cause dimmed output
module is limited. Refer to 'CONNECTION
WITH POWER SUPPLY' on page 2
3. Use bushing to protect wires
1