Hooping The Cap; Attaching The Cap Hoop To The Cap Driver; Removing The Cap Hoop From The Cap Driver; Removing The Cap Driver From The Embroidery Arm - Husqvarna Viking Platinum MN 1000 User Manual

HOOPING THE CAP

1. Take the cap hoop and connect the open metal notch
to the center tab on the cap station.
2. Slide and push the cap hoop towards the cap station.
3. Make sure all three spring locks are connected.
4. Unfasten the flexible metal band and position it to the
left of the cap hoop.
5. Pull back the sweatband of the cap.
6. Place the backing below the metal tab.
7. Slide in the sweatband between the metal tab and the
backing.
8. Make sure extra fabric is out of the way.
9. Position the flexible metal band back over the bill of
the cap.
1. Connect the clasp to the cap ring latch and snap it into
place.
11. To remove from the cap station, release the three
latches positioned.
ATTACHING THE CAP HOOP TO
THE CAP DRIVER
1. Rotate the cap hoop 90 degrees to either the left or
right.
2. Push the hoop onto the embroidery arm until the cap
hoop connects to the cap driver.
3. Rotate the cap hoop back into an upward position with
the bill of the cap facing upwards.
4. Align the center metal tab on the cap driver with the
metal opening of the cap hoop.
5. Grab the cap driver from the back.
6. Slide and push the cap hoop towards the cap driver.
7. Make sure all three spring locks are connected.
REMOVING THE CAP HOOP
FROM THE CAP DRIVER
1. Release the three latches on the cap driver.
2. Rotate the cap hoop 90 degrees to either the left or
right.
3. Slide the cap hoop away and off from the cap driver.
REMOVING THE CAP DRIVER FROM THE
EMBROIDERY ARM
1. Untighten and remove each screw.
2. Disengage the cap driver from its connection to the
metal dowels.
3. Slide the cap driver away from the embroidery machine.
PREPARATIONS – 25