Operation Menu Display On The Viewfinder Screen; Configuration Of The Operation Menu - Sony BVP-550 Operation Manual

4-4 OPERATION Menu Display on the Viewfinder
Screen
When you set the DISP switch to MENU, the
OPERATION menu appears on the viewfinder screen.
Use this menu to select settings, select items to be
displayed on the viewfinder screen, and the way the
items are displayed.
4-4-1 Configuration of the
OPERATION Menu
The OPERATION menu is displayed as individual
pages. The pages that make up the setup menu are
outlined in the table below.
Pages and functions of the setup menu
Page Page name Function
number
1 VF Selects the
DISPLAY display shown on
the viewfinder
screen
2 MARKER Sets markers
(box cursor)
3 GAIN SW Sets the GAIN
selector value
WIDE
4 Selects 16:9 or
SCREEN
4:3 mode
(OHB-
550WS/
550WSP
only)
5 MON OUT Sets the test
signal output
6 AUTO IRIS/ Auto iris/auto
AUTO KNEE knee (DCC)
(DCC)
7 STAND Selects use of
ALONE the video camera
as a stand-alone
unit
8 AUTO SET Auto Setup
UP
DIAGNOSIS Diagnosis
9
CAMERA ID Sets the camera
10
ID
VF DISP switch
MENU SEL control/button
Reference
"4-7-1 Selecting
Display Items"
"4-7-2 Setting the
Marker Display"
"4-7-3 Setting the
Gain Selector
Values"
"4-7-4 Selecting
the Aspect Ratio
(for OHB-550WS/
550WSP only)"
"4-7-5 Selecting
the Test Signal
Output"
"4-7-6 Automatic
Setting of Iris
Opening/Knee"
"4-7-7 Selecting
Functions"
"4-7-8 Auto Setup"
"4-7-9 Diagnosis"
"4-7-10 Setting the
Camera ID"
TOP Menu
The TOP menu screen indicates the entire
configuration of menu items.
To dispaly the TOP menu, set the DISP to MENU
(from OFF) while holding down the MENU SEL
control/button.
* TOP MENU *
m
Operation
Paint
Maintenance
Reference File
Triming File
System config
Notes
The contents of TOP menu may vary on the setting of
the switches on the internal AT board.
For details, refer to the maintenance manual.
The TOP menu has the following sub-menus:
OPERATION menu
This menu contains items contained for changing
camera settings to suit shooting conditions during
normal camera operations.
Switching the DISP to MENU usually displays this
menu.
PAINT menu
This menu contains items for making fine adjustments
to the image while monitoring the waveform of the
camera output on a waveform monitor or other output
device. This menu normally requires video engineer
support.
The settings of this menu can be done with the external
remote control panel or the master setup unit. This is
useful to use the video camera outdoors. This is
equivalent to PAINT menu of MSU-700.
The menus below contain items required for initial
setup or periodic maintenance of the video camera, and
are normally undisplayable.
For details on the setting of these menus, refer to the
maintenance manual.
MAINTENANCE menu: For maintenance purposes.
This is equivalent to MAINTENANCE menu of
MSU-700.
Chapter 4 Adjustments and Settings for Recording
Letter Ver.3.0
(Continued)
4-9
3-810-005-11(1)