Axis/Spindle Start-Up For The Digital Drive (As From Sw 3) - Siemens SINUMERIK 840C Installation Instructions Manual

5 Machine Data Dialog (MDD – as from SW 3)
5.4.2 Drive machine data for axes (FDD) and spindles (MSD)
Softkey This softkey contains status display, current values (drive/servo), status register,
Status Data motor encoder diagnostics, min., max. memory, monitor function, I/F mode,
diagnostics servo and communications servo/611D machine data. SW 3 also
contains monitoring memory location and transient recorder function machine
data.
Note Some of the machine data are parameter set dependent (see "Selecting a dis-
played parameter number").
5.4.3

Axis/spindle start-up for the digital drive (as from SW 3)

Note Two different drive installation versions exist:
S
S
See also Section 10.
Procedure The digital drives can be started up via the file functions by loading one of the
available TEA3 files or via standard start-up procedure with module and motor
selection.
Standard start-up Select the Drive MD area via the Diagnosis/Start-up/Machine data softkeys. You
are now in the drive configuration screen. The order of the slots symbolizes the
arrangement of the FDD/MSD modules in the control cabinet:
First of all for SW 3, for example, you enter number 1 in the field Slot for
module selection. As a result, the display cursor jumps to the drive number
input field. Here you enter the Drive No. (e.g. No. 1). For SW 4 only the drive
number has to be entered. Now switch the drive from Passive to Active using
the Toggle key. Now select the current module type via the Select module
softkey. Acknowledge your selection with ok.
Note When selecting the module please ensure that the order no. taken from the
selection list and hardware coincide. Some order numbers are nearly identical.
For example, MSD module 45/60/76A:
1. Order no.: 6SN112x–1AA00–0GA0
2. Order no.: 6SN112x–1AA01–0GA0
Follow the procedure above to enter several modules. Enter a consecutive num-
ber for the drive number for the next module.
Please note: With SW 3 you must also select a slot no.
5–24
Installation for analog drives is performed as usual by setting parameters
and potentiometer in the drive (for a more detailed description see Section
Start-up Axis and Spindle).
Digital drives are started-up by entering and installing the module and motor
type. The drive data are preset with standard data from the control by this
method.
The Flexible memory configuration function has been in-
troduced with SW 4. This means that during the first start-
up, the memory capacity and requirement are selected via
NC MD 60003 (memory for drive SW MSD) and NC MD
60004 (memory for drive SW FDD) by entering "yes". 194
Kbytes of memory are assigned to each function.
Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)