Advertisement
Mobile 1/4-Wave Antennas
5.
Complete the installation per installation pro-
cedure given for vehicles with single wall con-
struction. A completed mount is illustrated in
Figure 9.
Vehicles Without Dome Lights
When the vehicle has no dome light, and it is not feasi-
ble to remove the headlining to get to the inside sur-
face, proceed as follows:
4
Figure 7. Locking Nut Positioning
Figure 8. Locking Nut Tightening
1.
2.
3.
6880360B49-A
Locate the center of the roof and make sure
the area beneath this point is clear to allow
passage of a drill.
With a 3/4-inch diameter hole cutting saw
carefully cut a 3/4-inch hole from the top of
the roof through both thicknesses of metal.
Clean the metal in a neat circle around the
hole to assure a good contact between the roof
metal and the locking nut.
Remove any burrs and remove the filler sepa-
rating the roof thickness for a distance of 1/
4-inch back from the hole.
Installation
July, 2002
Advertisement
