Troubleshooting - Beko D1 7081 E Operation Manual

8

Troubleshooting

Problem Cause
Machine may have
Program switched to self
cannot be protection mode due to
started or an infrastructure problem
selected. (such as line voltage,
water pressure, etc.).
There may be some
water in your machine
Water in the
when you receive it. This
machine.
is from the quality control
process and is normal.
There is water
There might be problems
coming from
with hoses or the pump
the bottom of
filter.
the machine.
Tap may be turned off.
Water inlet hose might be
bent.
Machine does
not fill with
Water inlet filter might be
water.
clogged.
The loading door may be
ajar.
Water outlet hose might
Machine does
be clogged or twisted.
not discharge
Pump filter may be
water.
clogged.
Machine feet might have
not adjusted.
Transportation safety
bolts might have not
been removed.
There may be a small
Machine
amount of laundry in the
vibrates or
machine.
shakes.
The machine may be
overloaded or the clothes
may be distributed
unevenly.
There machine might be
touching a solid surface
Machine
stopped Machine can stop
shortly after temporarily due to low
the program voltage.
started.
Explanation / Suggestion
Reset your machine by pressing "Start/Pause/
Cancel" button for 3 seconds. (see, Canceling a
Program)
It is not harmful to your machine.
Be sure the seals of the water inlet hoses are
securely fitted.
Tightly attach the drain hose to the tap.
Make sure that the pump filter is completely
closed.
Open the inlet water taps fully.
Flatten the water intake hose.
Clean the water intake filter.
Close the loading door.
Clean or flatten the hose.
Clean the pump filter.
Adjust the machine feet.
Remove the transportation safety bolts.
Add more laundry to the machine.
Reduce the amount of laundry in the machine or
balance the load by hand.
Ensure that nothing touches the machine.
It will resume operating when the voltage is back
to the normal level.
28
TR