Power Supply - Black & Decker BFMAKB Instruction Manual

• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals inadvertently
come in contact with conductive materials such as keys, coins, hand tools and the
like. The US Department of Transportation Hazardous Material Regulations (HMR)
actually prohibit transporting batteries in commerce or on airplanes (i.e. packed in
suitcases and carryon luggage) UNLESS they are properly protected from short
circuits. So when transporting individual batteries, make sure that the battery
terminals are protected and well insulated from materials that could contact them
and cause a short circuit."
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Black & Decker Work Light. Read this
Instruction Manual and follow the instructions carefully before using your new
work light.
FEATURES
5
1
2
6
3
7
8
4
BFMAKB_ManualENSP_072715.indd 4-5
1. Magnetic base
2. Base cover
3. Base screw
4. Three (3) "AA" alkaline dry
cell batteries (may be sold
separately)
5. Hanging hook
6. 14 ultra bright LEDs
7. Pivot tube
8. Light mode pushbutton (High/
Medium/Off/Flash)
4

POWER SUPPLY

The unit is powered by three "AA" alkaline dry cell batteries (may be sold
separately). Unscrew the base cover screw (counter-clockwise) and remove the
base cover. Insert batteries as described in compartment, observing the cautions
that follow. Replace and secure the base cover by screwing the base cover screw
clockwise. Do not be over-tighten.
CAUTIONS
• When replacing the "AA" alkaline dry cell batteries: Do not mix old and new,
alkaline and rechargeable (nickel cadmium or nickel metal hydride) batteries.
Always insert batteries correctly with regard to polarity (+ and –), marked on the
battery and the equipment. Remove dead batteries immediately and dispose of per
local codes.
• Follow all warnings regarding batteries in the Important Safety Instructions section
of this manual.
OPERATING THE LIGHT
• Position the unit as desired. Press the light mode pushbutton on the front of the
unit.
• Press once for high intensity.
• Press again for medium intensity.
• Press a third time for to turn the light off.
• Press and hold the light mode pushbutton for about five seconds for flashing
LEDs.
Adjusting the pivot tube
The pivot tube allows the light to be tilted backward and forward to direct the
illumination upward or downward.
CAUTION: TO REDUCE THE RISK OF PRODUCT DAMAGE:
• Do not attempt to "force" the pivot tube beyond its maximum angle.
• The pivot tube was designed to tilt forward and backward only.
• The pivot tube was designed to be used when the unit is hanging or attached to a
surface using its magnetic base. Using it when the unit is placed on a level, non-
metallic surface may cause the light to fall over and sustain damage.
• NEVER attempt to rotate the light tube itself. Always use the pivot tube to adjust
the area of illumination.
5
7/27/2015 3:09:01 PM