System Panel Connector - Asus Rog Strix H370-I Gaming Manual

• For a fully configured system, we recommend that you use a power supply unit
(PSU) that complies with ATX 12V Specification 2.0 (or later version) and provides a
minimum power of 350 W.
• DO NOT forget to connect the 8-pin EATX12V power plug. Otherwise, the system will
not boot.
• We recommend that you use a PSU with a higher power output when configuring a
system with more power-consuming devices. The system may become unstable or
may not boot up if the power is inadequate.
7. System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
ROG STRIX H370-I GAMING System panel connector
• System power LED (2-pin PWR_LED)
This 2-pin connector is for the system power LED. Connect the chassis power LED
cable to this connector. The system power LED lights up when you turn on the system
power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin HDD_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable
to this connector. The HDD LED lights up or flashes when data is read from or written
to the HDD.
• ATX power button/soft-off button (2-pin PWR_BTN)
This connector is for the system power button.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot without
turning off the system power.
ROG STRIX H370-I GAMING
F_PANEL
(NC)
HWRST#
GND
Ground
PWR
PWR_LED- HDD_LED-
PWR_LED+ HDD_LED+
PIN 1
1-15