Download Print this page

Sharp 00ZFO3MKCUSME Service Manual

Facsimile option memory upgrade pwb

Advertisement

Quick Links

[1] General description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
[2] Installation procedure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
[3] Diagnostic mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
[4] Circuit schematics and parts layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
[5] Parts guide
Parts marked with "
" is important for maintaining the safety of the set. Be sure to replace these parts with specified ones for
maintaining the safety and performance of the set.
SERVICE MANUAL
CONTENTS
SHARP CORPORATION
1 - 1
No. 00ZFO3MKCUSME
FACSIMILE
OPTION MEMORY
UPGRADE PWB
FO-3MK
MODEL
This machine is an option memory unit applica-
ble to the machines FO-5700 (100V series).
This document has been published to be used
for after sales service only.
The contents are subject to change without notice.
FO-3MK

Advertisement

loading

Summary of Contents for Sharp 00ZFO3MKCUSME

  • Page 1 This machine is an option memory unit applica- ble to the machines FO-5700 (100V series). CONTENTS This document has been published to be used for after sales service only. The contents are subject to change without notice. 1 - 1 FO-3MK No. 00ZFO3MKCUSME FO-3MK...
  • Page 2 FO-3MK [1] General description This machine is an option memory unit applicable to the machines FO-5700 (100V series). It enhances the memory-aided functions such as sequential simultaneous sending and through-memory sub-stitute re- ception of facsimile. [2] Installation procedure (pay attention to static electricity) To install the option memory unit, check the following in advance.
  • Page 3 Then, the result table (Fig. 3) is printed. In case of mismatch, the buzzer emits 9 short tones . After that, the result table (Fig. 4) is output. 1) If any error occurred, check connection of connector CNOP (check for bending and breakage of pin of connector), check that the option memory unit has been mounted as specified, and then turn on again the power supply, and check.
  • Page 4 FO-3MK [4] Circuit schematics and parts layout HRW0502A – 3 –...
  • Page 5 FO-3MK C128 C123 C121 FLBK4 C124 – 4 –...
  • Page 6 FO-3MK – 5 –...
  • Page 7 FO-3MK Option memory PWB parts layout (Top side) Option memory PWB parts layout (Bottom side) – 6 –...
  • Page 8 Resistor(1/10W 0 Resistor(1/10W 91 Option memory PWB unit © 1999 BY SHARP CORPORATION ALL RIGHTS RESERVED. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission of the publisher.

This manual is also suitable for:

Fo-3mk