Selecting The Tray - Sharp AL-1215 Operation Manual

A: When copying in a one-sided to two-sided mode:
Use the original to copy key to select the desired one-sided to two-sided
copying mode (Turn on Long Edge or Turn on Short Edge). See the
illustrations on page 52.
B: When copying in the two-sided to two-sided mode:
Use the original to copy key to select the two-sided to two-sided copying
mode. The originals must be set in the RSPF before this mode can be set
in step 3 on page 48.
C: When copying in the two-sided to one-sided mode:
Use the original to copy key to select the two-sided to one-sided copying
mode. The originals must have been set in the RSPF in step 3 on page 48.
A
3
Select the copy settings. See "SET THE COPY QUANTITY"
(p.49), "EXPOSURE ADJUSTMENT/PHOTO COPYING" (p.49),
and "REDUCTION/ENLARGEMENT/ZOOM" (p.51).
Using the original table
If you are using the original table, copying is only possible in one sided to
two-sided mode ("A" above).
1 Press the start (
The original is scanned into the unit's memory and the number of the
copy quantity blinks in the display.
2 Place the original that you wish to copy onto the rear side of the
paper, and press the start (
Copying begins.
Using the RSPF
Press the start (

Selecting the tray

Press the tray select (
Each time you press the tray select (
indicated by the paper feed location indicator changes in
the following order: paper tray 1, paper tray 2, multi-
bypass tray.
B
) key.
) key again.
) key. Copying begins in the selected two-sided copy mode.
) key.
) key, the location
C
6
53