DS-1530HMI Mobile Alarm Terminal TABLE OF CONTENTS Chapter 1 Introduction ........................5 Overview........................... 5 Components ..........................5 Chapter 2 Connecting Cables ......................6 Chapter 3 Function Introduction ......................7 Indicator ............................ 7 Triggering Alarm ........................7 Signal Capture by Acceleration Sensor ..................7 Sending Signals from Terminal ....................
Page 3
(hereinafter referred to be “the Manual”) cannot be reproduced, changed, translated, or distributed, partially or wholly, by any means, without the prior written permission of Hikvision. Unless otherwise stipulated, Hikvision does not make any warranties, guarantees or representations, express or implied, regarding to the Manual.
Page 4
DS-1530HMI Mobile Alarm Terminal Regulatory Information FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Page 5
DS-1530HMI Mobile Alarm Terminal Safety Instruction • Install the monitor in a proper place where can’t affect drivers sight. • Do not disassemble the device by yourself. • Do not place the device in damp or hot environment. • Good ventilation is required for placing the device and do not place the device at the sun or extra bright places to ensure the LED screen can be read.
DVR’s status, as well as beneficial for malfunction investigation. 1.2 Components The DS-1530HMI Mobile Alarm Terminal is composed of panic button, ERROR, RECORD, and POWER indicators shown as the figure below. Figure 1. 1 Physical Interface Along with the mobile alarm terminal, an eight-meter long adapter cable is provided with one five-pin female aviation plug for connecting to DVR and the other H2 ×...
DS-1530HMI Mobile Alarm Terminal Chapter 2 Connecting Cables DS-1530HMI Mobile Alarm Terminal is connected with mobile DVR by RS-232 shown as the figure below. H2 × 2 Figure 2. 1 Connection...
DS-1530HMI Mobile Alarm Terminal Chapter 3 Function Introduction 3.1 Indicator After the mobile DVR and mobile alarm terminal have been connected, the indicator shows the mobile DVR’s working status. The terminal provides three LED indicators, respectively showing power status, recording status, and error status.
DS-1530HMI Mobile Alarm Terminal Figure 3. 1 Installation Position Calibration is required before enabling acceleration sensor. Within the 10s after the power indicator lighted, press the panic button for 3s, then the power indicator flashes for twice, indicating the calibration is successfully set.
DS-1530HMI Mobile Alarm Terminal Chapter 4 Specifications Table 4.1 specifications Model DS-1530HMI Power Supply 5V/30mA or 12V/15mA Indicator three indicators to indicate power, record and error status Dimensions (W× D× H) 80 mm × 30 mm × 19 mm (3.15" × 1.18" × 0.75") Working Temperature -10°...