Table of Contents
Advertisement
Reproduction Prohibited
SECTION 6
PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
Note on Printed Wiring Boards :
•
Through hole is omitted.
•
: Pattern on the side which is seen.
Note on Schematic Diagram :
•
Use caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
All capacitors are in µF unless otherwise noted. pF : µµF 50 WV
•
or less are not indicated except for electrolytics and tantalums.
•
All resistors are in
and 1/4 W (Chip resistors : 1/10W) unless
otherwise specified.
•
Chip resistors are 1/8 W or 1/10 W unless otherwise noted.
k
: 1000 , M
: 1000 k .
Note :
The components
identified by mark
or
!
dotted line with mark
!
are critical for safety.
Replace only with part
number specified.
Note on DC Power line :
Unit of voltage is V (volt)
•
+12V :
•
+8.0V :
•
+5.0V :
•
+3.5V :
•
IN :
•
OUT :
— GH013(31/41)-1 —
Note :
Les composants identifies par
une marque
sont critiques
!
pour la securite.
Ne les remplacer que par une
piece portant le nubero specifie.
•
+3.3V :
•
+2.5V :
•
+1.8V :
•
VC :
•
+1.5V :
•
Main Signal Line :
,
SCPH-30000 series and SCPH-35000 series
Hide quick links:
Advertisement
Table of Contents
