Drain Valve Washer Replacement; Service - Kenmore 153.586420 Use & Care Manual

Drain Valve Washer Replacement

NOTE: For replacement, use a 17/32" x 13/64" x 1/8" thick
washer available at your nearest hardware store. For
ordering a replacement washer, refer to the "Repair Parts
List" section.
• Before beginning turn "OFF" the electrical power supply to
the water heater.
• Follow "Draining" instructions in the "Service and Adjustment"
section.
• Turning counter clockwise, remove the hex cap below the
• screw handle.
• Remove the washer and put the new one in place.
• Screw the handle and cap assembly back into the drain valve
and retighten using a wrench. DO NOT OVER TIGHTEN.
• Follow "Filling the Water Heater" instructions in the
• "Installation Instructions" section.
• Check for leaks.
• Turn "ON" electric power to the water heater.

Service

Before calling for repair service, read the "Start Up Conditions"
and "Operational Conditions" found in the Troubleshooting
Guide of this manual.
If a condition persists or you are uncertain about the operation
of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at 1-844-553-6667.
19
FIGURE 28