Table of Contents
Advertisement
Operation
Channel Memory
Your TV can memorize and store all of the channels available. Once the channels are memorized,
you can use the CH
and CH
buttons to scan through the available channels.
Selecting the Broadcast Source
Before memorizing available channels, you must select what broadcast source your TV is connect-
ed to, either an antenna or a cable system.
Press the Menu button.
1
Move the joystick down to
select SETUP, then press the
joystick to enter.
Press the joystick to enter. The
2
channel setup menu will
appear. Move the joystick
down to select "Air or CATV".
If you are connected to an
3
antenna, leave "AIR" dis-
played. If you connected
cable, press the joystick to the
right to display the type of
cable system: "STD," "HRC,"
or "IRC."
you are not sure which type
of cable system you have,
contact your cable company.)
28
SETUP
Channel Setup
Closed Caption
Time
Language
English
Melody
Off
Blue Screen
Off
V-chip
Move
Enter
Menu
SETUP
Antenna
A
Air or CATV
AIR
Favorite Channel
Auto Channel Memory
Fine Tune
0
Add/Erase
Labeling
- - - -
Move
Select
Menu
SETUP
Antenna
A
Air or CATV
STD
Favorite Channel
Auto Channel Memory
Fine Tune
0
Add/Erase
Labeling
- - - -
(If
Move
Select
Menu
Storing Channels in Memory Automatically
First, select the broadcast source as
1
described on the previous page. With
the Channel Setup menu on screen,
move the joystick down to select "Auto
Channel Memory."
Press the joystick to enter. The TV will
2
begin memorizing all of the available
stations. Press the VOL+ button at any
time to interrupt the memorization
process.
If the TV set stops operation when Auto
Channel Memory runs, it is
recommended to re-run the program.
Note: When the ANT B mode is selected, the auto programming
runs on the main screen.
Adding and Erasing Channels
Use the number buttons to select the
1
channel you want to add or erase.
To add a channel, select it and press the
2
Add/Erase button on the remote control.
The channel will be added to the TV's
memory and the word "Channel added"
will appear in the corner of the screen.
To erase a channel, select it and then
3
press the Add/Erase button on the
remote control. The word "Channel
erased" will appear in the corner of the
screen. You can still view a channel that
has been erased from memory by using
the number buttons on the remote control
to select the channel directly.
SETUP
Antenna
A
Air or CATV
AIR
Favorite Channel
Auto Channel Memory
Fine Tune
0
Add/Erase
Labeling
- - - -
Move
Select
Menu
Auto Channel Memory
AIR 11
AIR 32
+ :
Stop
29
Advertisement
Table of Contents
