Honda 08L04-SZA-100 Installation Instructions

INSTALLATION
INSTRUCTIONS
PARTS LIST
2 Cross bars
2 Torx bolts
TOOLS AND SUPPLIES REQUIRED
Flat-tip screwdriver
Shop towel
T-30 Torx driver
Illustration of the Cross Bars on the Vehicle
Important:
The small torx screws on the
underside of one end of each crossbar
will break if overtightened.
are designed to not hold the end
piece tightly in place to allow for
vehicle flex.
© 2008 American Honda Motor Co., Inc. – All Rights Reserved.
P/N 08L04-SZA-100
CROSS BARS
They
Accessory
CROSS BARS
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by skilled
technicians who have the proper tools, equipment, and
training to correctly and safely add equipment to your
vehicle. These procedures should not be attempted by
"do-it-yourselfers."
NOTE:
• The weight of cargo must not exceed the maximum
weight capacity 75 kg (165 lbs).
• Wipe and clean the roof racks before installing the cross
bar.
• Be extremely careful not to damage the roof and other
finished surfaces of the body when installing the cross
bar.
Installing the Cross Bars
1. Remove the left rear roof rack cover and right rear roof
rack cover from the roof rack by disengaging two clips
each.
FRONT
7D0401B
AII 39283 (0805)
Application
2009 PILOT
2
1
2 CLIPS
LEFT FRONT
ROOF RACK
COVER
2 CLIPS
ROOF RACK
08L04-SZA-1000-91
Publications No.
AII 39283
Issue Date
MAY 2008
LEFT REAR
ROOF RACK
COVER
1 of 3